how to format my hard drive windows vista

The only hardware changed has bee the HDD. I have not touched the BIOS since taking ownership of the PC as new a little over 2 years ago - is it possible for it to change itself? Note: If you are upgrading your PC to Windows Vista SP1 or later or Windows 7. I disconnected the drive and booted normally, came online and wrote this. preparing an Advanced Format hard drive for a Microsoft Windows. I shut it down and changed the SATA port it was connected to on the motherboard and tried again - same result. I did copy some files across with no problems and all seemed fine.

Perhaps I should have re-booted after the format but I didn`t. The options were not greyed out at this point. I formatted the new drive fully - all appeared well. I fitted a brand new drive, the PC booted normally and the drive was not recognised in `My Computer. This is normal for Windows and you never want to change these. If you have never partitioned before, notice that there are already three partitions. You will notice all drives displayed clearly. This will open the Disk Management console. BUT, if I have a second drive fitted I have a boot problem in as much as the PC wont boot but just sits with a lot of drive activity after the `loading` screen and before the `Welcome` screen. From here, press enter or click on âCreate and format hard disk partitionsâ. Using Acronis TI I cloned my primary drive to the suspect drive - it boots and runs OK. No I haven`t tried MaxBlast but doesn`t the new SeaTools do the same job? Sorry I have no idea how to post a screenshot of Disk Management.

How to format my hard drive windows vista